Industrial Grade Fixed Width Spreader

About This Spreader

The Industrial Grade (IG) Spreader is available in nine standard fixed width versions, but any reasonable width above 4 ft and less than 16 ft is available by special request. The standard sizes are IG4, IG5, IG6, IG7, IG8, IG9, IG10, IG11, and IG12. The IG4 up to IG8 are the recommended sizes for use with most tracked skid loaders that can handle a 1500LB bucket load.

The IG10 is the largest recommended version for use with a small dump truck such as a 4×4 tandem rear axle F-350. The height adjustment can be performed at any time without using tools by cranking 2000 LB screw jacks until the material spreader is at the height needed. The width can be offset to one side relative to the truck (spread a road and the shoulder while the truck is still on the road) by unbolting the center tray of the spreader and re-bolting it in an offset position.

The industrial grade spreader has a light weight walk on screed. The walk on screed allows workers to cross from one side of the spreader to the other while working, and also allows workers to ride the spreader and keep the material distributed evenly in the spreader using a rake or shovel.

Features

- The Industrial Grade (IG) Spreader is made light weight and strong with extra reinforcement where it counts. Your vehicle should be carrying extra aggregate, not extra spreader.
- All fasteners are Grade 8 and galvanized for chemical and corrosion resistance.
- The spreader is composed of High Grade bright finish A-36 Steel, laser cut and professionally welded.
- Wide skids with an AR-400 wear plate bottom surface is optional for the Industrial Grade Spreader.
- Mechanical 2000 lb capacity jacks for height and width adjustment are standard. They are easily removed for replacement.
- Adjustable Width versions are IG4-6, IG5-8, IG6-10, & IG7-12
- Fixed Width versions are IG4, IG5, IG6, IG7, IG8, IG9, IG10, IG11, & IG12
- The height of each side of the spreader is independently adjustable to provide or correct for ground slope.
- The hitch system has quick detach pins for easy removal of the spreader from the truck.
- All adjustments for height can be made without tools. Width adjustments will need two 3/4″ wrenches, or Custom bolt bars with T-handle nuts are available as an option on the Industrial Grade Spreader.

Interested in buying from us but have questions about the type of spreader that’s right for you?

Contact us so that we can better serve you.

See our Accessories page for a description of these items that can make the experience of using one of our Material Spreaders easier and more profitable.See the Downloads page for Order Forms and other information.